About collecting digitized points using a 3D scanner

[chinmay.chinara]

@rpa19008 glad it worked for you.

・We use a 64ch cap, but I think the cap montage on Brainstorm is set to 68ch. Is it necessary to individually delete points that do not exist on the cap we are actually using, such as PO9 and PO10?

@tmedani can you advice here ?

・We would like to digitize using individual anatomy data, rather than the default anatomy data, in order to enable better signal source estimation. Is this possible? If so, could you please tell me how?

Absolutely it is possible to do so. Follow the steps as under:

1. Lets say your subject ID is Sub1. Switch to anatomy tab and create a new subject under named "3DScanner_Sub1"
   

   

2. This should create a new subject in the anatomy tab as under
   

   

3. Import your individual anatomy data inside it.

4. Click on File > Digitize > 3D scanner and in the subject ID pop up enter Sub1 and click OK.
   

   

5. Then continue with 3D scanner digitization as before.